Seaward 3 burner LPG with oven 22w x 19-1/2d x 22”h never used $650.00

Pedestal seat with adjustable height pedestal and removable base white with grey piping $150.00

Vetus “Happy7 Elephant non-skid decking Deck covering, made of rubber, cork and plastic. This material has incredibly high non-slip $150 pr roll 35” x 94” 3 rolls available

Scotty 1106 Depthpower 60" Electric Downrigger The Scotty 1106 Depthpower 60" Electric Downrigger features a telescoping stainless steel boom capable of reaching a whopping 60" and collapsing to 36" $350.00

SCOTTY-INC DOWNRIGGER LONGARM COMBO-MAN | 1091Part Telescopes to 60". Collapses to 36" for storage $250.00

Super Rare “Piece Boat SOLO Kayak” modular 3 piece 10’8” fiberglass kayak. by the Piece Watercraft company of 71 Marsh st Noank CT. super light at 40lbs with capacity of 235 lbs $500

Light House at Castle Hill Newport RI 32” x 48” $150.00

2014 Tohatsu 9.8hp short shaft low hours super clean $1200

RL93268 REAL 4.25# 1 Gallon Propane Tank Locker Kit by Sure Marine Products

Constructed of roto molded polyethylene, assembled with stainless quick release latches, rubber gasket, propane, vent and wire bulkhead fittings, and regulator / solenoid assembly with gauge.  Measures 14" Wide x 14" Deep x 12" High (16-1/4" Wide with mounting flanges.)

4.25# Steel Tank Included. 

12 vdc Solenoid switch included.

Norseman Hydraulic 7.8 ton hydraulic cutter for up to 5/8” $350.00

15- 12" Teak Spindles from taft rail each spindle measures 12" l. with an overall of 12-3/4" .The base and top measure 2-1/4" in dia and tapers to 1-3/4 at its narrowest point Includes bronze 5-1/6" rods

Davis Wheel-A-Weigh Standard Launching Wheels

Wheel-A-Weight transom wheels are an easy way to get your small craft to and from the water quickly and safely. Wheel-A-Weigh is mounted wide on the transom to distribute the load and leave clearance for outboard motors. A detent pin on each pivot bracket lets you position the wheels up or down, or remove them completely for storage. The Wheel-A-Weigh features a 316 stainless steel frame and pivot brackets. It also features precision molded, non-corrosive wheel hubs and 10" inflatable tires. The standard Wheel-A-Weigh has a 220 lbs. capacity and can handle most small boats with motors up to 10 HP.

Note: This product is not designed to be towed behind a vehicle.

Features:

• Portable and removable

• 316 Stainless steel frames and pivot brackets

• Inflatable tires

• Precision molded, non-corrosive wheel hubs

• Stainless steel installation hardware included

• Easy to follow instructions

Specifications:

• 10" Inflatable Tires

• For loads up to 220lbs (100kg)

• Weight: 9lbs 4oz (4.2kg)

Mahogany folding 4 step boarding ladder 14”W X 36” L $200.00

Mistral SST 10.5 Windsurfer 1 carbon mast,1-fg mast,1- 4.6 sail,1-5.7 sail 1-7.0 sail i lrg boom, 1- sm boom board has small repair but the tip $200

Todd Boarding steps Dimensions: 17" H x 23 1/2" W x 26 3/4"D $125.00

Swing back cooler seat measures Seat measures 32”w x 16”d x 20”h base measures 34”w x 16” d $295.00

Xantrex Freedom 458 Inverter/Charger -model 81-2010-12-12 volt 2000 amp 100 amp charger $750.00

Jabsco manual pump clutch from Jabsco raw water Pump - 6590-0005 $200

Cabinet door push button chrome latch set $20.00 - 50 available

Edson Radar dome top plate and mounting base fig 975 / B480 $175.00